Ryobi RY34420 - Manual

RYOBI ART WORK
Art Part No. : 987000-439 Rev. 01
Where Used : 987000-439
Refer to Drawings for Dimensions.
987000-439
3-20-09 (REV:01)
Material: 60lb. Stock Paper.
Color: Lift-off Bright Pink.
FRONT
Cold Engine:
Warm Engine:
To Stop:
PRESS and HOLD switch until
engine stops
Carefully pour fuel into the tank. Avoid spillage. Immediately replace
fuel cap and hand tighten. Wipe up any fuel spillage.
PRIME
press the PRIMER BULB 10 times slowly.
DO NOT squeeze TRIGGER LOCK or THROTTLE TRIGGER until
engine starts and runs.
SET
START lever to " START " position.
PULL
rope until engine starts.
1 GALLON
GAS
Squeeze trigger to run.
10x
START
RUN
5
1
2
3
4
6
7
5
1
2
3
4
6
7
LUBRICANT
ENGINE STARTING PROCEDURE
WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided.
Later uses: Check engine lubricant level and add lubricant if needed.
For any questions about operating or maintaining your product, call the Ryobi ® Help Line!
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
For additional registration instruction, refer to operator’s manual.
CALL
1-800-860-4050
www.ry
obitool
s.com
Squeeze trigger and pull rope until engine starts.