Ryobi BTS211 - Manual (Page 17)

17
ASSEMbLy
Fig. 8
Fig. 9
miter
Fence
riP Fence
Blade
WrencHes
storaGe
HooK
storaGe
HooK
TO STORE THE TAbLE SAw ACCESSORIES
See Figures 8 - 9.
The table saw has two convenient storage areas (one on
either side of the saw cabinet) specifically designed for the
saw’s accessories.
When not in use, store the accessories securely by snapping
each accessory in place.
TO MOVE THE LEG STAND
See Figure 10.
 Holding the leg stand firmly, pull the leg stand toward
you until the leg stand and saw are balanced on the
wheels.
 Push the saw to the desired location then either open the
leg stand for immediate saw operation or store the saw
in a dry environment.
TO REMOVE/REPLACE THE THROAT PLATE
See Figure 11.
 Lower the blade by turning the height/bevel adjusting
handwheel counterclockwise.
 Loosen the screws in the throat plate.
 Lift the throat plate from the saw.
 To reinstall the throat plate, align the holes in the throat
plate with the holes in the saw table.
 Retighten the screws, being careful not to overtighten,
which can cause the throat plate to bow or bend.
NOTE: Securely tighten throat plate screws. Do not allow
the throat plate to bow up above the table surface.
Fig. 10
Fig. 11
saW taBle
tHroat
Plate
screW