Ryobi BTS211 - Manual (Page 19)

19
ASSEMbLy
TO INSTALL bLADE GUARD ASSEMbLy
See Figure 14.
Proper installation of the blade guard assembly means that
the saw blade and spreader are in alignment. ALWAYS align
the spreader to the saw blade prior to turning on the table
saw.
 Lower the blade.
 Loosen the wing nut and slide the spreader between the
mounting plate and flat washer. Partially retighten the
wing nut.
 Check the blade and spreader alignment.
NOTE: Blade alignment with the spreader can be
adjusted for different blade widths. Refer to: To Check,
and Align the Spreader, Saw blade, and blade Guard
Assembly in the Adjustment section. Check the blade
guard assembly for clearances and free movement.
 Tighten wing nut securely.
NOTE: If the wing nut and washers are completely removed,
reinstall in the following order: flat washer, star washer, and
wing nut.
TO INSTALL DUST bAG
See Figure 15.
 Slide the elbow inside the dust chute on the back of the
table saw.
 Slide the dust bag into the elbow.
NOTE: For efficient operation, empty the dust bag before it
is half full. This will permit better air flow through the bag.
OPERATION
wARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is suf-
ficient to inflict severe injury.
wARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
Fig. 14
mountinG
Plate
WinG
nut
sPreader
anti-KicKBacK
PaWls
Fig. 15
dust
BaG
dust
cHute
elBoW
Flat
WasHer
star WasHer
WinG nut