Ryobi RTS21 - Manual (Page 19)

19
ASSEMBLY
TO ASSEMBLE THE SLIDING TABLE
ASSEMBLY
See Figures 17 - 18.
To install sliding table assembly:

Locate the sliding table assembly.
 Unlock the front and back table locking levers.
 Insert sliding table assembly into table locking levers.
 Push the table assembly until it rests against the saw
table and is completely closed.
 Install phillips head screw into hole on the bottom of the
rear extension rod to hold sliding table assembly into
locking levers.
 Lock the front and back table locking levers.
To install indicator:

Press the end cap over the front extension rod as shown
in figure 18.
 Locate the indicator.
 Slip the indicator in the slot on the front rail.
 Fit the top slot in the indicator over the detent on the end
plug and the bottom slot over the screw hole on the end
plug.
 Insert a screw into the bottom slot of the indicator, the hole
in the end plug and the extension rod. Tighten securely,
but do not overtighten. Overtighting may crush extension
rod ends.
Fig. 18
SCREW
INDICATOR
TABLE
LOCKING
LEVER
REAR
EXTENSION ROD
EXTENSION
ROD
Fig. 17
END CAP
SLIDING
TABLE
ASSEMBLY
DETENT