Chrysler 2009 Aspen Hybrid - Manual (Page 31)

U.S. Federal regulations require that upon transfer of
vehicle ownership, the seller certify to the purchaser the
correct mileage that the vehicle has been driven. There-
fore, if the odometer reading is changed during repair or
replacement, be sure to keep a record of the reading
before and after the service so that the correct mileage can
be determined.
18. Fog Light Indicator
This light illuminates when the fog lights are on.
19. Electronic Stability Program (ESP) Indicator Light
The yellow ESP indicator light in the speedom-
eter area illuminates with the key in the igni-
tion switch turned to the ON/RUN position. It
should go out with the engine running. The
ESP/TCS indicator light starts to flash as soon as the tires
lose traction and the ESP system becomes active. The
ESP/TCS indicator light also flashes when TCS is active
as well as when the ABS is active. If the ESP/TCS
indicator light begins to flash during acceleration, ease
up on the accelerator and apply as little throttle as
possible. Be sure to adapt your speed and driving to the
prevailing road conditions. The ESP/TCS indicator light
becomes illuminated when the ESP-OFF button has been
pressed or ESP is only partially available, caused by lack
of engine management or brake thermal model.
20. Transmission Temperature Indicator
This light indicates that there is excessive trans-
mission fluid temperature that might occur
with severe usage, such as trailer towing. If this
light comes on, stop the vehicle, press the
TOW/HAUL button, and run the engine at idle or faster
with the transmission in NEUTRAL until the light goes
off.
UNDERSTANDING YOUR INSTRUMENT PANEL 29
4