SoundMax SM-CDM1039 - Manual (Page 15)

15
Radio operations
BAND selection
Press repeatedly SUB/BAND button to select your desired radio band in radio mode: FM1, FM2, FM3, AM1
(MW1), AM2 (MW2). Each band can store 6 preset stations, for a total of 30 preset memory stations.
Tuning
Rotate repeatedly UP/DN knob to manually adjust the radio frequency.
Rotate and hold UP/DN knob, the radio will seek to the next up or down strong and clear frequency
station automatically. Repeat this action to seek for other desired stations. To stop automatic search,
rotate UP/DN knob.
Automatic store/Scan
Automatic store: Press and hold F/PS button, the receiver will automatically scan and save stations for
the current band.
Scan: Press F/PS button once to scan the saved stations in each band.
Programming stations
There are 6 numbered preset buttons, under which you can store and recall stations for each band. Select the
needed station, then press and hold a preset button. The station will be saved in the memory under the
corresponding number. To recall a stored station, press the corresponding preset button.
Local/distant reception
Press SEL button repeatedly to select LOC OFF (LOC ON). If LOC ON is displayed, it means that local station
reception is activated. LOC OFF means that distant stations with both strong and weak signal are received.
Switch between LOC OFF and LOC ON by rotating VOL knob.
Mono/stereo reception (for FM rado)
Press SEL button to select STEREO FM reception or MONO reception. Mono receptions enables achieve a
better signal quality due to noise reduction.