Dish Network Platinum Remote Control - Manual (Page 10)

8 121716
4. Press the blank POWER button.
5. Press the UP or DOWN ARROW button until
the device turns off. You will have to do this
repeatedly to scan through all codes.
Note : Do not press the ARROW buttons too
quickly because you could skip over the code
for your device.
Note : The mode button for the device will flash rapidly eight
times when you’ve scanned all the codes for that device.
6. If the remote reaches the correct code, the device
turns off. When this happens, press the POUND ( # )
button to store the code in the remote.
7. Press the blank POWER button to turn the device
back on.
8. Try some other buttons to make sure they work.
Sometimes, the blank POWER button works
when other buttons don’t.
C HECK THE D EVICE C ODES
You can find out what device code you’ve set for each remote control
mode. Here’s what to do:
1. Press and hold the mode button for the device you want the
remote to control, for about three seconds. When all the other
mode buttons light up, let go of the mode button - that mode
button should now be flashing.
For example, hold the TV mode button for a TV until all of the
other mode buttons light. When you let go, the TV mode light
will flash.
2. Press the POUND ( # ) button twice. The mode button
flashes the number for each digit of the device code,
with a pause between the groups of flashes. A quick
flash is for zero. For example, if the code is 570, the
mode button flashes five times, pauses, flashes seven times,
pauses, and flashes once quickly.
text_dishpvr.fm Page 8 Friday, February 28, 2003 1:22 PM