DeLonghi EMFPS 60 B - Manual (Page 39)

39
REPLACING THE OVEN LAMP
WARNING: Ensure the appliance is switched off before replacing the lamp
to avoid the possibility of electric shock.
■ Let the oven cavity and the heating elements to cool down;
■ Switch off the electrical supply;
LEFT LAMP:
■ Remove the left sliding shelf and the side catalytic panel by unscrewing the
fixing screws (see chapter REMOVING AND REASSEMBLING THE SLIDING
SHELVES AND THE CATALYTIC PANELS at page 37).
■ Press down from the top the protective cover A (fig. 6.4) and remove it by
rotating on the lower side. IMPORTANT: never use screwdrivers or other
utensils to remove the cover A. This could damage the enamel of the oven or
the lampholder. Operate only by hands.
■ Unscrew and replace the bulb B with a new one suitable for high tempera-
tures (300°C) having the following specifications: 230-240V 50 Hz, 25W, E14.
■ Refit the protective cover A operating in reverse order. ATTENTION: the notch
in the inner edge of the cover must be oriented toward the lamp.
■ Assemble the side catalytic panel and the left sliding shelf.
TOP RIGHT LAMP:
■ Remove the protective cover C (fig. 6.4);
■ Unscrew and replace the bulb B with a new one suitable for high tempera-
tures (300°C) having the following specifications: 230-240V 50 Hz, 25W, E14
■ Refit the protective cover;
NOTE: Oven bulb replacement is not covered by your guarantee.
A
B B
C
1
2
A
A
Fig. 6.4