Nexen FMCE 625 801683 - Manual (Page 4)

1 FORM NO. L-20321-C-0402
FMCBE REMOVAL
PARTS CONVERSION
1. Remove the Plug (Item 27 or 32) and loosen the
Set Screw (Item 26 or 31) securing the FMCBE to
the motor or Input Unit (See Figure 1).
2. On Model 625, remove the Socket Head Cap
Screws (Item 29) and Lock Washers (Item 30) that
secure the FMCBE to the motor or Input Unit; then,
slide the motor or Input Unit off the FMCBE (See
Figure 2).
On Models 875 and 1125, remove the Socket
Head Cap Screws (Item 27) that secure the
FMCBE Housing (Item 1) to the Female Pilot (Item
26); then, remove the Socket Head Cap Screws
(Item 29) and Lock Washers (Item 30) to remove
the Female Pilot from the motor or Input Unit (See
Figure 2).
Plug
(Item 27 or 32)
Set Screw
(Item 26 or 31)
FIGURE 1
Socket Head
Cap Screw
(Item 27)
Socket Head Cap Screw
and Lock Washer
(Items 29 and 30)
Female Pilot
(Item 26)
FIGURE 2
STUB SHAFT, LOCKING KEY, BEARINGS, AND O-RING SEALS
1. Remove the four Socket Head Cap Screws (Item
13) and slide the Male Pilot (Item 20) and the Stub
Shaft (Item 23) out of the Air Chamber (Item 12)
(See Figure 3).
2. Remove the old O-ring Seals (Item 21 and 22) from
the Male Pilot (Item 20) (See Figure 3).
FIGURE 3
12
22 21
20
13
23