Naim Audio NAP S1 - Manual (Page 16)

5 . 0 N A C S 1 A N D N A P S 1 O P E R A T I O N
5 . 3 B A L A N C E C O N T R O L
NAC S1 balance can be adjusted using the handset <bal or bal> keys. Balance adjustment will
temporarily replace volume on the NAC S1 volume display.
5 . 4 I L L U M I N A T I O N C O N T R O L
NAC S1 and NAP S1 illumination has normal and vivid operational modes and can also be adjusted
for brightness. Illumination control covers button illumination, volume control illumination,
input display illumination and logo illumination.
N O T E . If your preamplifier and power amplifiers are connected using CAN bus, illumination
adjustments will automatically apply to all.
Illumination modes can be alternately selected by pressing the top panel disp button or the handset
disp key.
In vivid mode, all illumination will remain permanently lit while the units are operational. Vivid
mode illumination brightness can be adjusted using the handset disp- and disp+ keys.
In normal illumination mode only logo illumination remains lit permanently. Button illumination,
volume control illumination and input display illumination will fade up on control operations and
fade out again three seconds following control operations. Normal mode illumination brightness
can be adjusted using the handset disp- and disp+ keys.
N O T E . Normal illumination mode fade-out following switch-on is ten seconds.
5 . 5 S T A T E M E N T R E M O T E H A N D S E T
Statement preamplifiers are supplied with a remote control handset that both duplicates all the
Statement top panel controls and provides transport control for many Naim source and streaming
components. The remote handset, its buttons and their functions are illustrated in Diagram 5.6.
Four AAA batteries must be installed in the remote handset before it can be used. To install the
batteries remove the bottom end cap by unscrewing the two allen bolts using the 2.5mm allen key
supplied. Insert the batteries into the remote handset body taking care with their polarity.
Replace the end cap and lightly tighten the allen bolts. 5 . 6 R E M O T E H A N D S E T F U N C T I O N S
Press to select standby mode
or to wake units from standby.
Press to select the next input.
Press to mute audio or to
restore audio.
Press to increase volume.
Press to decrease volume.
Press to adjust balance.
Not used with NAC S1 or NAP S1.
Use for transport control on Naim
source components.
Press to reduce illumination
brightness, to change
illumination mode and to
increase illumination brightness.
Press to select
the previous input.
Not used with NAC S1
or NAP S1. Use for transport
control on Naim
source components.
3 0 3 1