Lenco BTT-6 - Manual (Page 8)

8
Establishing a Bluetooth® connection
Bluetooth® LED indicator information:
The Bluetooth® LED will burn continuously if the device is searching for a Bluetooth® device.
The Bluetooth® LED will blink if it is paired with a Bluetooth® device.
The Bluetooth® information of this product is:
Name: Lenco
Password / PIN: 0000
Before you start the configuration of the Bluetooth® connection, make sure that the
Bluetooth® module on your smartphone or tablet is turned on.
Important note: Some Bluetooth® devices might not be compatible with this device.
 Turn on the tower by pressing the standby button on the remote control or tower.
 Go to Bluetooth® mode by pressing the BT button.
 Wait until the Bluetooth® indicator LED burns continuously.
 Search for Lenco on your smartphone or tablet and connect with it.
 If the pairing is successful the Bluetooth® indicator LED starts blinking.
Auto-pairing: When the Bluetooth® connection is lost, you can turn the device off and on to
reconnect with the last paired smartphone or tablet. You can also switch to AUX mode by
pressing the AUX button on the remote control or tower and then switch back to Bluetooth®
mode by pressing the BT button on the remote control or tower.
Manual pairing: If you would like to pair/connect to another smartphone or tablet, press the
BT button to enter Bluetooth® mode. In the first 30 seconds the device will search for the last
paired Bluetooth® device. After these 30 seconds you can follow steps 4 and 5 to pair
another smartphone or tablet.
Note: If the tower cannot find any Bluetooth ® device for an hour, the tower will automatically shut
down.
Basic operation
 Use the standby button on the tower or remote control to turn the unit on and
off.
 Volume + / - buttons on the tower or remote control. Press + to increase the
volume, press - to decrease the volume.
 Mute button on the tower or remote control. Press this button to turn off the
volume. Press it again to turn on the volume.