Lenco CR-3300 - Manual (Page 4)

TO SET THE ALARM
1. Press and hold the Alarm set button while repeating step 2 described under " TO SET THE TIME" to set the
desired wake-up time.
2. To check the correct alarm time, press the Alarm set button.
USING THE RADIO / BUZZER ALARM
1. Set the alarm as shown in "TO SET THE ALARM".
2. Follow the procedure in "LISTEN TO THE RADIO" to tune the desired station.
3. Set the Volume Control to your required listening level.
4. Slide the Function Switch to "AUTO" position. The radio will turn on to wake you up at the preset time.
5. To wake to the buzzer instead of the radio , set the alarm as shown in "TO SET THE ALARM".
Slide the Function Switch to "BUZZER" position. The buzzer will turn on to wake you up at the preset time.
6. To turn off the radio or buzzer, slide the Function Switch to "OFF" position or press the Alarm set button.
SNOOZE FUNCTION
When the radio or buzzer sounds, press the Snooze button to switch off the alarm. Approximately 9 minutes later, the alarm
will switch on again. This snooze cycle will be activated up to 5 times within an hour period. To stop the snooze cycle,
slide the Function switch to "OFF" position or press Alarm set button .
GB 3
SLEEP FUNCTION
1. Set the Function Switch to "AUTO" position.
2. Press the Sleep button. The clock display will show 59 minutes . The radio turns on and off automatically after 59
minutes.
3. To reduce the automatic shut off time, hold down the Sleep button to adjust to the desired sleep time.
4. To turn the radio off prior to the preset sleep time, simply press the Alarm button.
ANTENNA
The FM radio has a flexible wire antenna on the back side of the unit, uncoil the wire and extend to its full length for best
reception.
SPECIFICATIONS
Power Source: AC : 230V ~ 50Hz
Dc : 9v backup (1 x 006P)
Frequency range: FM : 87.5 - 108 MHz
Power Consumption 3.5 W
Dimension: 177(L) x 119(D) x 58 (H) mm
Weight: 0.5 kg
Due to continuing improvement, the features and the design are subject to change without notice.
Where to place the item :
Today’s furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive range
of cleaning products. Therefore, the possibility that some of these substances contain components that react adversely to
the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the appliance can cause
discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface.
For information and support, www.lenco.eu
If at any time in the future you should need to dispose of this product please note that : Waste electrical products
should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive)
CR3300 LENCO ENG FM IM 230V RED 4 4 3/5/2009 5:36:52 PM