Lenco CS-321 - Manual (Page 25)

25
OPERATION
USB PLAY OPERATION
On the front panel of the unit, there is an
USB interface (12). You can connect an
USB driver through this interface (12).
When you connect an USB driver through
the interface, the unit will search the MP3
files or WMA files in the USB driver and
start to play MP3 files or WMA files
automatically. If in other mode, you can
also press MODE button (11) to select USB
mode.
It supports the MP3/WMA file in the device,
the operation please refer to the following
instruction.
SELECTING SONGS IN SINGLE STEP
Press
button (24) or button (2) to
move to the previous song or the following
song. Track number shows on display.
SELECTING DIRECTORY UP/DOWN
Press -10
button (16) or +10 button
(15) to select up ten songs or down ten
songs.
PAUSING PLAYING
Press
button (21) to pause playing.
Press it again to resume playing.
PREVIEWING ALL FILES
Press INT button (20) to INTRO each file
stored in USB device. Shortly press again
to stop intro and start to play.
REPEATING PLAYING
Press RPT button (19) to continuously
repeat the same file. Press it again to stop
repeat.
PLAYING IN RANDOM ORDER
Shortly press RDM button (17) to play all
files stored in USB device in random order.
Press it again to cancel the function.
CAUTION
： ： ： ：
When there are important files in the USB
device, do not connect it to the main unit to
play, because any wrong operation may
cause files loss. And our company
assumes no responsibility for this.
SD/MMC OPERATION
There is a SD/MMC interface (22) on the
front panel of the unit.
When you insert a SD/MMC card in the
SD/MMC interface, the unit will search the
MP3 files or WMA files in the card and start
to play MP3 files or WMA files automatically.
The operation is the same with the USB
play operation described above.
If in other mode, you can also press MODE
button (11) to select SD/MMC mode.
When there are important files in the
SD/MMC card, do not connect it to the
main unit to play.
RESET FUNCTION
RESET button (25) must be activated with
either a ballpoint pen or thin metal object.
The RESET button is to be activated for the
following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: if press RESET button (25), the unit
can’t work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the
socket on the front panel.