Lenco DVL-2455 - Manual (Page 12)

12
Signal Information (For DTV only): Press [▼] and [OK] to enter "Signal Information"
submenu. This menu displays signal details, including Channel, Network,Modulation,
Quality and Strength.
Picture menu
Press [MENU] to display the main menu.
Press [◄/►] to select "PICTURE" in the main
menu, then press [▼] and [OK] to enter.
Picture Mode: Press [▼] and [OK] to enter
"Picture Mode" submenu. Press [◄/►] to
change the picture mode in sequence: Standard
— Dynamic — Mild — User. You can press
[PMODE] repeatedly on the remote control to change the picture mode directly.
Colour Temp: Press [►] or [OK] to enter "Colour Temp" submenu. Press [▲/▼] to
change the colour temperature in sequence: Warm — COOL — USER — Medium.
Press [◄/►] to adjust contrast,Brightness colour,tint,sharpness in user mode. Noise
Reduction: Press [▼] or [OK] to enter "Noise Reduction" submenu. Press [o/p] to
change the noise reduction in sequence: Off — Low — Middle — High.
Sound menu
Press [MENU] to display the main menu.
Press [◄/►] to select "SOUND" in the main
menu, then press [▼] and [OK] to enter.
Sound Mode: Press [▼] and [OK] to enter
"Sound Mode"submenu. Press [◄/►] to
change the sound mode in sequence: Standard
— Music — Movie — Sports — User. You can
press [SMODE] repeatedly on the remote control to change the sound mode directly.
Press [▲/▼] to adjust treble,hass in user mode.
Balance: use the same way as above.
Auto Volume: Press [▼] or [OK] to set the automatic volume level to "On" or "Off".
SPDIF Mode: Press [▼] or [OK] to set the SPDIF mode to "Auto" or "PCM".
Surround Sound: Press [▼/▲] button to select Surround Sound, then press button to
enter sub-menu.Press [▼/▲] button to adjust.(Available Surround Sound: Off,
Surround).
EQ: Press [▼/▲] button to select EQ, then press [OK] button to enter submenu.
Press [▼/▲] button to select. Press [▼/▲] button to adjust.(Available EQ: 120Hz,
500Hz, 1.5KHz, 5KHz,10KHz).