Lenco DVP-741 - Manual (Page 6)

Remote Control Introduction
Remote Control
Note:
1. In this manual, will be used to represent different NAVIGATION ARROWS on
the remote respectively.
2. In order to operate any of the remote functions, you must first press the Power button on the
DVD player.
3. Some of the keys is multiple key. They can be used in DVD mode or in DVB mode.
CR2025
1
2
HOW TO REPLACE THE BATTERY
STEP 1: PUSH THE BUTTON TOWARD LEFT;
STEP 2: PULL THE BATTERY LOADER OUT.
BATTERIES
INCORRECT USE OF BATTERIES MAY CAUSE THEM TO LEAK, CORRODE OR EXPLODE.
Be sure to place the batteries in the correct direction.
It is dangerous to charge/heat/open or short-circuit the batteries.
Do not leave dead or expired batteries or mix old/new batteries.
When not using the remote control for a long duration of time, remove the batteries. When
operating range becomes reduced, replace all batteries with new, fresh ones.
If leakage from the battery occurs, wipe the battery liquid from the battery compartment, then
replace.
4