Lenco L-81 USB - Manual (Page 4)

1– Start/stop buttons Tonearm lift
Press this button to start or stop the platter.
2– Platter
The platter is equipped with a slip mat. This makes it easier to manipulate the record for scratch performances.
3– USB&SD SOCKET
Plug USB stick and SD card into, the LED will indicate while worked.
4– Target light
Insert target light to the deck and it will light up.
5– 33 rpm Speed select buttons
Used to select the desired speed.
Press the “33” button to select the 33rpm speed.
6– 45,78 rpm Speed select buttons
Press the “45” button to select the 45rpm speed.
Press the “33” and “45” at the same time to select the 78rpm speed.
7– Reverse button
This button is used to reverse rotate the platter.
8– Headshell
Install cartridge here. When installing a cartridge, refer to the installation instructions supplied by the
manufacture of that cartridge. During installation, attach the stylus protector to guard the stylus tip from
damage.
Attach wires as follows:
White (L+) Left channel +
Blue (L -) Left channel –
Red (R+) Right channel+
Green (R-) Right channel –
9– Headshell locking nut
Attach the head shell by inserting it into the front end of the tone arm and then turn the locking nut clockwise.
10– Tone arm
This is a fully manual tone arm. To start playback, gently place the stylus on the record using head shell finger
support OR use the tone arm lifter(see 12).
11– 45rpm adaptor
Place on center spindle for playing 7” records with large center holes.
12– Tonearm lift
Controls the up and down action of the tone arm.
13– Anti-skate knob
This applies inward force to the tone arm so it does’ skip outward across the record due to the centrifugal force
of the record spinning. Cartridge manufacturers usually specify the proper setting of this.
Description