Lenco SB-210BT - Manual (Page 11)

GB-11
Troubleshooting
Symptom Possible Cause Solution
Radio sound
distorted.
1. The station is not tuned
in.
2. There is a poor signal in
the area.
1. Fine tune the station.
2. Unwind the wire antenna
for best reception
No radio
sound.
1. The unit is not at tuner
mode.
2. The volume has been
muted or is on the
minimum setting.
1. Press SOURCE button
repeatedly until switching
to tuner.
2. Adjust the volume level or
press the MUTE button to
resume audio.
No Sound at
Bluetooth®
mode.
1. The unit is not
connected with the
audio source device.
2. The unit is placed out of
the range
3. The volume has been
muted or is on the
minimum setting.
1. Follow the manual to
connect the audio source
device to the unit.
2. Relocate the unit within
Bluetooth® operating
range.
3. Adjust the volume level or
press the MUTE button to
resume audio.
Sound is
distorted at
Bluetooth®/A
UX/Line in
modes.
Sound source is distorted. If the original sound source
of the external device is poor
quality or with distortion and
noise, it will be easily
noticed with high-power
speakers. Try a different
audio source.
No sound at
AUX/Line in
modes.
1. The unit is not
connected the external
appliance properly.
2. The volume has been
muted or is on the
minimum setting.
1. Follow the manual to
reconnect the audio
appliance to the unit.
2. Adjust the volume level or
press MUTE button to
resume audio.
Specifications
Power source: AC 100~240V 50Hz/60Hz
Power consumption: 50W
Battery of remote control: CR2025 x 1
Receiving bands: FM 87.5 -108 MHz
Bluetooth® compatible: support A2DP
Dimensions: 941.8(L) x 60.5(W) x 110.5(H) mm
Operating Humidity Range: 10 % to 75 %