Lenco SCD-26 User Manual

Page 7

Advertising
background image

GB 5

CLEANING THE UNIT

Do not use volatile chemicals on this unit. Clean by lightly

wiping with a soft cloth.

IMPORTANT NOTE

If an abnormal display indication or an operating problem

occurs, disconnect the AC power cord and remove the

batteries. Wait at least 5 seconds, then reconnect the AC

power cord or reinstall the batteries.

WARNING

Should the CD door be opened before the reading of the CD

is completed, a jamming noise may occur. This is resolved

by closing the CD door.

CLEANING A CD

If the CD skips or will not play , the disc may need cleaning

. Before playing, wipe the disc from the centre out with a

cleaning cloth. After playing, store the disc in its case.

MAINTENANCE

CLEANING THE CD LENS

If the CD lens is dusty, clean it with a brush-blower. Blow

several times on the lens and remove the dust with the

brush. Finger prints may be removed with a cotton swab

moistened with alcohol.

CD SECTION

Channels:

2 channels

S / N ratio:

60 dB

Wow & Flutter:

undetectable

Sampling frequency:

44.1 kHz 8 x over sampling

Quantization:

1 bit DA converter

Pick up light source:

Semi - conductor laser

Pick up wave length

790 nm

RADIO SECTION

Tuning ranges:

FM 87.5 - 108 MHz

Antennas:

FM Rod antenna

GENERAL

Output power:

1 W + 1 W (RMS)

Power consumption:

13.5 W

Speaker:

3 " 8 OHM

Phones jack:

3.5MM

Power source:

AC : 230V ~ 50Hz

DC : 9V ( 6 x 1.5V LR14/ "C"/UM2 )

Dimensions:

224(L) x 234(D) x 126(H)mm

Weight

1.4 KGS

Due to continuing improvement, the features and the design are subject to change without notice.

Where to place the item :
Today’s furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive range

of cleaning products. Therefore, the possibility that some of these substances contain components that react adversely to

the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the appliance can cause

discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface.

SPECIFICATIONS

Advertising