Altera Remote Update IP Core - Manual (Page 34)

Name Port Required
?
Description
asmi_rden
Output
No Read enable signal to
altasmi_parallel
component.
Available when the
check_app_pof
parameter is
set to TRUE. This pin enables the read operation
on the ALTASMI_PARALLEL IP core.
Wire this pin to the
asmi_rden
input port of the
ALTASMI_PARALLEL IP core.
Parameters
For Cyclone IV devices, mapping to each parameter type and corresponding parameter bit width is
defined as follow:
Table 13: Mapping to Each Parameter Type and Corresponding Parameter Bit Width
Bit Parameter Width Comments
000 Master State Machine
Current State Mode (Read
Only)
2
00—Factory mode.
01—Application mode.
11—Application mode with the master state machine
user watchdog timer enabled.
001 Force early CONF_DONE
(cd_early) check
1
—
010 Watchdog Timeout Value
12 Width of 12 when writing.
The 12 bits for writing are the upper 12 bits of the 29-
bit Watchdog Timeout Value
29 Width of 29 when reading.
011 Watchdog Enable 1 —
34 Parameters
UG-31005
2015.04.07
Altera Corporation Altera Remote Update IP Core User Guide
Send Feedback