Owner’s manual, Product identification, Local codes – Desa VS18NR User Manual

Page 3: Unpacking product features, Remote control accessories

Advertising
background image

3

103449

OWNER’S MANUAL

PRODUCT
IDENTIFICATION

Figure 1 - VS24NR Shown

LOCAL CODES

Install and use heater with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANS Z223
, also known as NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Note:

Where listed vented decorative logs

are required, thermostat operation is not
permitted.

1.

Remove logs and heater base assem-
bly from carton.

Note:

Do not pick up

heater base assembly by burners. This
could damage heater. Always handle
base assembly by grate.

2.

Remove all protective packaging ap-
plied to logs and heater for shipment.

3.

Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.

UNPACKING

PRODUCT
FEATURES

OPERATION

This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
realistic, dancing yellow flames. This heater
is designed for vent-free operation with flue
damper closed. It has been tested and ap-
proved to ANS Z21.11.2 standard for
unvented heaters. State and local codes in
some areas prohibit the use of vent-free
heaters. This heater may also be operated as
a vented decorative (ANS Z21.60) product
by opening the flue damper (non-thermostat
operation only).

SAFETY PILOT

This heater has a pilot with an Oxygen
Depletion Sensor Shutoff System (ODS).
The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off
the heater if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.

AU

TO

MAN

OFF

ST

ATUS

ON

LO

HI

TEMP

Left
Front
Branch

Control Knob

Rear Log

Base
Assembly

Front
Burner

Piezo
Ignitor

Rear
Burner

Crossover Log

Top Middle
Log

Bottom
Middle
Log

Right Front
Branch

Selector
Switch
(Optional)

Flame
Adjustment
Knob

Remote
Control
(Optional)

CAUTION: Do not remove the

warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty information.

REMOTE CONTROL
ACCESSORIES

There are four optional remote controls that
can be purchased separately for this log
heater:

• wall switch

• wall thermostat

• hand-held ON/OFF remote

• hand-held thermostat remote

See Accessories, page 23.

The wall thermostat or hand-held thermo-
stat may not be used where vented decora-
tive listing is required.

Advertising
This manual is related to the following products: