Subaru 2008 IMPREZA - Manual (Page 135)

“ON” position, the indication does not
flash.
NOTE
The outside temperature indication
may differ from the actual outside
temperature. The road surface freeze
warning indication should be treated
only as a guide. Be sure to check the
condition of the road surface before
driving.
& Average fuel consumption
1) U.S.-spec. models
2) Canada-spec. models
This indication shows the average rate of
fuel consumption since the trip meter was
last reset.
Pressing the trip knob toggles the indica-
tion between the average fuel consump-
tion corresponding to the A trip meter
indication and the average fuel consump-
tion corresponding to the B trip meter
indication.
When either of the trip meter indications is
reset, the corresponding average fuel
consumption value is also reset.
NOTE
. The indicated values vary in accor-
dance with changes in the vehicle
’s
running conditions. Also, the indicated
values may differ slightly from the
actual values and should thus be
treated only as a guide.
. When either trip meter indication is
reset, the average fuel consumption
corresponding to that trip meter indica-
tion is not shown until the vehicle has
subsequently covered a distance of 1
mile (or 1 km).
Light control switch
CAUTION
Use of any lights for a long period of
time while the engine is not running
can cause the battery to discharge.
The light control switch only operates
when the ignition key is inserted into the
ignition switch.
Regardless of the position of the light
control switch, the illuminated lights are
turned off when the ignition key is
removed from the ignition switch.
NOTE
. Even if the ignition key is removed
from the ignition switch, the lights can
be illuminated by operating the light
control switch position from
“OFF” to
“ ” and “ ”.
. If the lights are illuminated when the
ignition key is removed from the igni-
tion switch, the chirp sound informs
the driver that the lights are illumi-
nated.
Instruments and controls
3-27
– CONTINUED –