MIPRO ma101c - Manual (Page 6)

(2) Battery Charging Procedures:
a) Please make sure the inbuilt rechargeable batteries are fully
charged before and after use. Battery itself has such a special
characteristic of self-discharging gradually over a long period of
time. Therefore, if the system will not be used for a long
period of time, please make sure the batteries are fully
charged before storing them properly. Company Warranty
DOES NOT apply to over-discharged batteries, hence, please
ensure the batteries are recharged every 3 months.
b) Simply plug the connector of the supplied DC adapter to the
DC 18V Power Input Jack (8) and plug the other end into an
available AC socket.
c) Charging begins immediately, and will be indicated by a
flashing green LED. If the green LED is not flashing, it may
due to excessive power over-drain and it takes longer for the
greed LED to flash. This is normal and not faulty. If after a
while and still no flashing green LED, the battery may be faulty.
d) If a battery replacement is needed, open the battery
compartment and exchange with a new battery. Insert the
battery with the right polarity.
e) Battery is an expendable item. Under normal operation,
MIPRO offers one year limited warranty.
f) When experiencing short operating time after batteries are fully
charged, it is often a sign with aging batteries. Both
rechargeable batteries must be replaced at your earliest
convenience.
(3) Auxiliary In
a) Connect a line-level source, such as portable cassette or CD
player into the Aux input jack(7).
b) Power on PA system (4) and adjust for volume loudness.
(4) Installation
a) Hand Carrying: Remove the shoulder belt (10) and store in the
Battery Compartment (11) directly above the battery. Use the
Fixed Handle for transport.
b) Shoulder Carrying: Remove shoulder belt (10) from the Battery
Compartment (11) and hook the connector around the rod on
top of the unit, between the Fixed Handle and the Speaker.
c) Mic Stand Mounting: The MA-101 will fit directly on top of a
mic stand using the threaded mount(12) with no additional
hardware. Simply align the hold with the protruding end of the
mic stand and thread it on the stand.
- 3 -