MIPRO ma101c - Manual (Page 7)

- 4 -
1. Lay the PA system on a flat surface.
2. Press down on the two fasteners at the top of battery compartment.
The compartment door will now swing down on its hinge.
3. Remove the interior rear panel of the battery compartment by sliding
it up. Use caution, as the battery may "spring" forward when you
release this panel. Carefully remove the battery.
4. Insert a fully charged battery, observed the correct polarity. The two
terminals on the battery should be near the top of the battery with
the printed side up. This alignment corresponds with the springs and
terminals inside the unit.
5. Press the battery into the unit, holding it firmly against the springs,
while sliding the rear panel back into space. This may require two
hands.
6. Close the battery compartment door. Lift up on the two fasteners
until they "click" into place.
With proper care and charging, it is unlikely that it will be
necessary to replace the MA-101 battery. However, there is an access
panel provided for this purpose. If extended periods of use are required
without time to recharge the battery, you may wish to have a second
battery fully charged and ready to install and use once the existing on
is drained. The battery is a standard 12V/2.7A gel cell and is available
from MIPRO.