Alto Professional AEQ231 - Manual (Page 7)

7
Connecting the AEQ231 from Mixer auxiliary outputs (“In-Line”)
Adding EQ to stage monitors is helpful in controlling feedback and shaping the perfect monitor mix. In this
configuration, EQ will be applied to the monitor path only.
Note: We recommended using pre-fader auxiliary sends for controlling stage monitor levels.
1.
Connect Mixer auxiliary Output 1 to the XLR Balanced Input or 1/4” TRS on AEQ231 Channel 1.
2. Connect AEQ231 Channel 1 output to amplifier input or powered loudspeaker input. The EQ is now “in-line”
between the mixer Auxiliary output and loudspeaker amplifier.
3. For the connection between the mixer’s auxiliary output 2 and Channel 2 input on AEQ231 follow the same
pattern as seen in steps 1-2.
Inserting the AEQ231 on a Mixer Channel Insert
Stereo Insert cable (1 TRS 1/4” Male to 2 Mono 1/4” Male) will be required for this configuration. AEQ231 channel 1 is
listed for example only. Both channels can be used in this configuration. Use only one AEQ231 channel per mixer
channel insert.
1.
Connect the TRS end of the Insert cable to the mixer’s Channel Insert.
2. Connect the Tip end of the Insert cable to the balanced 1/4” Channel 1 input of AEQ231.
3. Connect the Ring end of the Insert cable to the balanced 1/4” Channel 1 output of AEQ231.
Channel 1 IN
Channel 2 IN
From mixer auxiliary
output
To power amplifier
input or powered
speakers
Channel 2 IN
Channel 2 OUT
From mixer
auxiliary output
Channel 1 OUT
From mixer auxiliary
output
Channel Insert
CH 1
IN
CH 1
OUT