Alto Professional RMX508DFX - Manual (Page 9)

9
TECHNICAL SPECIFICATIONS
MONO INPUT CHANNELS
• Microphone input: Electronically balanced, discrete input configuration
• Frequency response: 10Hz to 55kHz, +/–3dB
• Distortion: (THD & N) 0.006% at +4dBu, 1kHz
• Gain: 50dB (MIC)
•
SNR: (Signal to Noise Ratio) >90dB
• Line input: Electronically balanced
• Frequency response: 10Hz to 55kHz, +/–3dB
• Distortion: (THD & N) 0.04% at +4dBu, 1kHz
• Gain: 30dB
STEREO INPUT CHANNELS
• Line input: Unbalanced
• Frequency response: 10Hz to 55kHz, +/–3dB
• Distortion: (THD & N) 0.006% at +4dBu, 1kHz
IMPEDANCES
• Microphone input: 1.4k Ohm
• Channel Insert return: 2.5K Ohm
•
All other inputs: 10k Ohm or greater
• Tape out: 1k Ohm
• All other outputs: 120 Ohm
EQUALIZATION
•
Hi shelving: +/–15dB @12kHz
• Mid bell: +/–15dB @2.5kHz
• Low shelving: +/–15dB @ 80Hz
DSP SECTION
•
A/D and D/A converters: 24-bit
• DSP resolution: 24-bit
EFFECTS
• Hall, Room, Vocal & Plate reverbs Mono & Stereo DELAY (Max delay time 650ms) Chorus, Flanger
& Reverb Modulations, Reverb+delay, reverb+chorus, Reverb+flanger combinations
• Presets: 16
• Controls: 16-position PRESET Selector; 16-position Variation selector
Clip LED; Mute Switch with LED indicator
POWER SUPPLY MAIN VOLTAGE
• 100-120VAC ~ 60Hz
• 220-240VAC ~ 50Hz
• Fuse 100 ~ 120V: T6.3AL; 210 ~ 240V: T3.15AL
• Inrush current at initial switch-on: 12 A
• Inrush current after power supply interruption: 13.99 A
STEREO MODE
• 230 W @ 4 ohm(RMS) THD=1%
•
150 W @ 8 ohm(RMS) THD=1%
• Bridge mode 460 W @ 8 ohm(RMS) THD=1%
PHYSICAL DIMENSIONS (W×D×H)
• 550mm×220mm×310mm (8.66"×12.20"×21.65")
WEIGHT
• (Net) 13.2kg (28.70 lb)
• (Gross) 15.93kg (35.11lb)