Alto Professional TMX120DFX - Manual (Page 7)

7
INTERNAL EFFECTS
48.
PRESETS Control - Adjust this knob to select the internal effect you want to use.
49. VARIATIONS Control - 16 variations for each preset to further adjust the internal effects.
50. DFX MUTE Switch & PEAK LED - Activates/deactivates the internal effects. This LED lights
up when the input signal is too strong. When the effect module is muted, this LED also lights
up.
REAR PANEL
51.
POWER ON/OFF Switch - Turns the main
power ON and OFF.
52. AC Inlet with FUSE Holder - Connect the
mixer to an AC power outlet with the
supplied AC cord.
Please check the voltage available in your
country and how the voltage for your mixer is
configured before attempting to connect the
mixer to the main AC.
53. VENTS - These vents are used for ventilation and heat dissipation.
54. SPEAKERS Jacks These jacks are used to connect speakers.
Note: In order to avoid damage to the built-in amplifier, pay attention to the
allowed impedance of the speaker. Very low load impedances may damage
the amplifier.
1. VOCAL 1
2. VOCAL 2
3. LARGE HALL
4. SMALL HALL
5. LARGE ROOM
6. SMALL ROOM
7. PLATE
8. TAPE REVERB
9. SPRING REVERB
10. MONO DELAY
11. STEREO DELAY
12. FLANGER
13. CHORUS
14. REVERB+DELAY
15. REVERB+FLANGER
16. REVERB+CHORUS
48
49
50
52
OUTPUT
B 1+
LOCK LOCK
2 2 1 1
1-
A B
1+
1- B A 2+
2- BRIDGE 1+
2+
51
53
54