Applied Motion TXM24C-1CG - Manual (Page 2)

▪ Download and install Step-Servo Quick Tuner software, available at www.applied-motion.com.
▪ Launch the software by clicking Start/Programs/Applied Motion Products/Step-Servo Quick Tuner
▪ If you have any questions or comments, please call Applied Motion Products
Customer Support 800-525-1609 or visit us online www.applied-motion.com.
If you have any questions or comments, please call Applied Motion Products Customer Support:
(800) 525-1609, or visit us online at www.applied-motion.com.
404 Westridge Dr.
Watsonville, CA 95076, USA
1-800-525-1609
Tel (831) 761-6555
Fax (831) 761-6544
www.applied-motion.com
TXM24C Quick Setup Guide
920-0093 Rev. A
Step2 - Step-Servo Quick Tuner
Step3 - Configuration
a) Apply power to the drive.
b) Use the Step-Servo Quick Tuner to set up the motor current, limit switches, I/O, tuning and Q program.
c) Set BitRate, Node ID
CANopen Bitrate - AMP CANopen drives have two set tings, one for Bit Rate and another for Node ID. The Bit Rate
is configured using Step-Servo Quick Tuner.
The Node ID is configured using Step-Servo Quick Tuner also. Valid ranges for the Node ID are 0x01 through 0x7F.
Node ID 0x00 is reserved in accordance to DS301 specification.
Note: The Node ID and Bit Rate is captured only after a power cycle, or after a network reset command has been
sent. Changing the switches while the drive is powered on will NOT change the Node ID and Bit Rate until one of
these conditions has also been met.
d) The Step-Servo Quick Tuner includes a self test option (under the Drive menu) to verify that the TXM24C and
power supply are correctly wired and configured.
e) When configuration is complete, exit the Step-Servo Quick Tuner the drive will automatically switch to CANopen
Mode.