Step3 – Applied Motion TXM24Q-1AG User Manual
Page 2
Step3
a)
Apply power to the drive. The drive model and firmware revision should be automatically displayed. If they are
not, check the com port setting.
b)
Follow the configuration instructions in the Step-Servo Quick Tuner help screens.
c)
The Step-Servo Quick Tuner software can be used to set up your drive to operate in several different modes
including: Pulse & Direction, Analog Velocity, and SCL.
d)
Step-Servo Quick Tuner includes a self test option (under the Drive menu) to verify that the TXM and power
supply are correctly wired and configured.
If you have any questions or comments, please call Applied Motion Products Customer Support:
(800) 525-1609, or visit us online at www.applied-motion.com.
404 Westridge Dr.
Watsonville, CA 95076, USA
1-800-525-1609
Tel (831) 761-6555
Fax (831) 761-6544
www.applied-motion.com
TXM24-S/Q Quick Setup Guide
Recommended RS-485 Adapter
USB-COMi-M (P/N 8500-003)
• Available from Applied Motion Product
• Converts RS-422 and RS-485 to USB
For four wire RS-485, set SW2 to OFF and SW1,3,4 to
ON. On the USB-COMi-M screw terminal connector:
• Connect pin 1 to RX-
• Connect pin 2 to RX+
• Connect pin 3 to TX+
• Connect pin 4 to TX-
• Connect pin 6 to GND
• The DB-9 connector is not used
1
ON
2 3 4
4 Wire
RS-485
920-0092 Rev A