Applied Motion SVAC3-IP-E120 - Manual (Page 2)

a) Apply power to the drive.
b) Enter the proper IP address (refer to step 1d above), then select the “Drive”
tab and press the “Ping” button. You should receive a response similar to
that shown here.
c) Select the appropriate operating mode for your drive.
d) If using an Applied Motion servomotor, press the “Open” button, navigate to
the SVAC3 folder, and select a tuning file. Select the file that most closely
matches your inertia load. The file names indicate the inertia ratio for
which they were optimized. For example, the file M0200-101-4-X5.svt was
optimized for the M0200-101-4 motor at a 5:1 inertia ratio.
Step 5
a) Select the “Motor - Encoder” tab and confirm settings for motor
maximum current and pole count, as well as the encoder resolution
are correct. If you are using a non-AMP motor, these data must be
obtained from your motor’s datasheet.
b) Execute the Timing Wizard, following the on-screen prompts. This will
ensure that the drive can properly commutate the motor.
Step 6
a) Select the “Tuning - Sampling” tab.
b) If a factory tuning file was used in Step 5, the system is already tuned for the specified load. If using
a third-party motor, the system must be tuned manually. Consult the Quick Tuner™ Software Manual
for step-by-step tuning instructions.
The Quick Tuner™ Software Manual should be considered required reading for anyone tuning a servo
system.
Step 7
Select the “Inputs - Outputs” tab, and configure any dedicated-function I/O your application
may require.
Step 8
Download your settings to the drive. Your drive is now configured for use.
Step 9
If you have any questions or comments, please call
Applied Motion Products Customer Support:
(800) 525-1609, or visit us online:
www.applied-motion.com.
404 Westridge Dr.
Watsonville, CA 95076
Tel: 800-525-1609
Fax: 831-761 -6544
www.applied-motion.com
920-0052 rev A