Unvented natural gas fireplace lfp33nr, Installation, Continued – Desa LFP33NR User Manual

Page 14: Installing batteries for rm4

Advertising
background image

14

104887

UNVENTED NATURAL GAS FIREPLACE

LFP33NR

INSTALLATION

Continued

OPTIONAL WIRELESS HAND-
HELD REMOTE CONTROL
ACCESSORY RM4

Installing Remote Receiver Unit

1.

Disconnect switch wires from the con-
trol valve.

2.

Remove screws and nuts attaching
switchplate. Save screws and nuts to
attach receiver.

3.

Remove switch plate (see Figure 26).
Discard after removing.

4.

Install remote receiver unit onto remote
switch bracket using screws and nuts
removed in step 2. See Figure 27

5.

Route wires through hole in the upper
portion of the switch plate (Figure 27).
Connect wires as shown in Figure 28.
(Black and blue wires are not used for
this application.)

Figure 26 - Switch Plate and Wiring
Harness

Figure 29 - Installing Battery in Remote
Receiver

Screw

Switch Plate

Wires

Figure 27 - Installing Remote Receiver

Installing Batteries in Hand-Held
Remote Control Unit

1.

Remove battery cover on front of re-
mote control unit following direction
of arrow.

2. Insert two AAA batteries following dia-

gram in battery housing area.

3.

Replace battery cover onto remote con-
trol unit.

Figure 30 - Installing Battery in Hand-
Held Remote Control Unit

AAA
Batteries

Battery
Cover

Remote
Control Unit

Battery
Housing

Figure 28 - Connecting Wires

Red Wire From
Receiver

Valve

White Wire
From Receiver

INSTALLING BATTERIES
FOR RM4

Four AA and two AAA batteries (not in-
cluded) are required to operate this heater
with the wireless hand held remote control
set. AA batteries must be installed in the
receiver and AAA batteries in the hand-held
remote control unit.

Note:

Only use alkaline

batteries.

Installing Batteries in Receiver

1.

Locate back of receiver behind the re-
mote switch bracket under the firebox
bottom.

2.

Slide the battery door off of the receiver
in the direction of the arrow on the door.

3.

Insert the four AA batteries according
to Figure 29.

4.

Slide the battery door back into position.

Remote Receiver

Screws

Remote Switch
Bracket

Battery Door

AA Batteries

Remote
Receiver

Ignitor

Nuts

Terminal
Wires

+

+

-

-

-

+

+

+

-

-

+

Advertising