Planning the installation, Cabinet cut-out (continued), Support platform – Dacor MOV230 User Manual
Page 10
8
Planning the Installation
Cabinet Cut-Out (continued)
Support Platform
WARNING
The top surface of the support platform must be installed
flush with the cutout in the front of the cabinet or wall
and any trim. Failure to install the platform properly
may cause the exhaust vent to deform and/or become
obstructed. An obstructed exhaust area may cause the
oven to malfunction. See below.
Provide a platform within the cabinet to support the oven.
A properly supported piece of 3/4” (19mm) thick plywood is
recommended.
All contact surfaces between the appliance and the cabi-
net, including the support platform, must be sturdy, straight
and level. The oven cannot be leveled after it has been
installed.
Support Platform
WRONG
Cabinet Front
or Wall
Exhaust Vent
do not block
Oven Door
Deformed Sheet Metal
Blocking Vent
Cool Air Intake
(do not block)
Exhaust Deflector
(do not bend)
RIGHT
Sheet Metal on
Bottom of Oven