Operating heater, Continued, Ghrc series operation – Desa A Remote-Ready User Manual

Page 21: Ghrcta series operation

Advertising
background image

104415

For more information, visit www.desatech.com

For more information, visit www.desatech.com

21

21

OPERATING HEATER

Continued

Figure 32 - Setting the Selector switch, Control Knob, and Flame
Adjustment Knob for Remote Operation

GHRC Series Operation:

2a. Press the ON/OFF button to turn the burners on and off.

When turning burners off, the pilot will remain lit.

GHRCTA Series Operation:

2b. Press the AUTO/ON/OFF button on the hand-held remote

control (see Figure 33). The lights to the left of the button
will show AUTO, ON, or OFF.
• In the ON mode, the burners will ignite. The heater is in

manual mode when ON is lit.

• In the AUTO mode, the thermostat in the hand-held re-

mote unit controls the room temperature. To increase the
room temperature, press the top arrow of the TEMP but-
ton. To lower the room temperature, press the bottom ar-
row of the TEMP button. At higher settings the heater
will run longer.

IMPORTANT:

This remote control has been specially engi-

neered to take an air temperature sample every 5.5 minutes
in the auto mode. It will not respond immediately to the tem-
perature setting being turned up or down.

IMPORTANT:

The hand-held remote control unit must be

near the heater. Do not keep the hand-held remote control
unit too close to the heater. The thermostat on the hand-
held remote control unit will heat up too quickly and turn
the heater off.

3.

To turn the burner off, press the AUTO/ON/OFF button un-
til OFF lights. The pilot will remain lit.

IMPORTANT:

To turn the pilot off, manually turn the con-

trol knob on the heater to the OFF position.

Figure 33 - Thermostat Hand-Held Remote Control Unit
Selections (GHRCTA Only)

Increases Room
Temperature in
AUTO Mode

Decreases Room
Temperature in
AUTO Mode

Turns Burners
On or Off and
Allows You to
Choose the Auto
Setting

Shows
Temperature
Setting

The Log Heater
will Automatically
Cycle between
Pilot and the Heat
Setting that has
been Selected

O

F

F

PIL

OT

O

N

LO

IH

ON
OFF
REMOTE

Selector Toggle Switch
(Optional Remote Control)

Control Knob in
On Position

Flame Adjustment Knob

OPERATING HEATER (REMOTE-READY MODELS)

Optional Remote Operation (Cont.)

Advertising
This manual is related to the following products: