Digital Spectrum MemoryFrame MF-8000 - Manual (Page 32)

• If the update is available. Select ‘OK’ and press ‘Enter’ will download the updates
• Depending on the network speed, traffic, and the size of the updates, it might take a few
minutes to download the updates
• If the update is available and you do not want to update at this time, select ‘Not at this time’
and press ‘Enter’
• Once the download is complete, the frame will upgrade the software and reboot upon
completion.
To Register your Digital Picture Frame:
See section ‘Push slideshow to your Digital Picture Frame’ above to register your fame and the benefit of
registering your frame.
To Restore Default Settings:
With slideshow playing:
• Press ‘Menu’ on the remote control to go to the main menu
Or at the main menu:
• Select ‘Settings’ and press ‘Enter’ on the remote control
• Select ‘Restore default settings’ and press ‘Enter’ on the remote control
To enable Auto Check Update:
With slideshow playing:
• Press ‘Menu’ on the remote control to go to the main menu
Or at the main menu:
• Select ‘Settings’ and press ‘Enter’ on the remote control
• Select ‘Auto Check Update – yes/no’ and toggle ‘Auto Check Update – yes/no’ by pressing
‘Enter’ on the remote control
When Auto Check Update is enabled, frame will check for latest update when switched on.
To Set Standby Time:
With slideshow playing:
• Press ‘Menu’ on the remote control to go to the main menu
Or at the main menu:
• Select ‘Settings’ and press ‘Enter’
• Select ‘Set standby time’ and press ‘Enter’
• Use ‘Up’ ‘Down’ buttons on the remote control to set the ‘hours’ when the Digital Picture
Frame will turn off
• Press ‘Right’ on the remote control to select ‘Off mins’
• Use ‘Up’ ‘Down’ buttons on the remote control to set the ‘minutes’ when the Digital Picture
Frame will turn off
• Press ‘Right’ on the remote control to select ‘Off AM/PM’
• Use ‘Up’ ‘Down’ buttons on the remote control to set the AM or PM
• Press ‘Right’ on the remote control to select ‘On hours’
• Use ‘Up’ ‘Down’ buttons on the remote control to set the ‘hours’ when the Digital Picture
Frame will turn on
• Press ‘Right’ on the remote control to select ‘On mins’
• Use ‘Up’ ‘Down’ buttons on the remote control to set the ‘minutes’ when the Digital Picture
Frame will turn on
• Press ‘Right’ on the remote control to select ‘On AM/PM’
• Use ‘Up’ ‘Down’ buttons on the remote control to set the AM or PM
• Press ‘Enter’ on the remote control to set the standby time.
To Enable Standby (Yes or No):
With slideshow playing:
• Press ‘Menu’ on the remote control to go to the main menu