d&b Z5351 E8 Horizontal bracket - Manual (Page 5)

5. Assembly
Fig. 6: Tie bar of the bracket
Fixing to walls or ceilings
Two mounting holes 9 mm (0.35“) are provided on the back of the
bracket for fixing the bracket directly to walls or ceilings or other
suitable surfaces.
Attaching the bracket to the cabinet
NOTICE: Only use the supplied and specified screws [2]. Always use
the spring washer
[3] and U-washer [4] to prevent the bolts from
slackening.
Tools required: Open ended spanner/wrench (size #17).
1. Fit the cabinet to the prepared bracket.
2. Bolt the bracket to the cabinet.
3. Set the desired angle before finally tightening the screws.
6. Maintenance and care
In case of mobile use of the bracket please observe the following notes.
Storing/Transport
Due to its surface treatment the bracket is temporarily protected against
moisture. However, ensure the bracket is in a dry state while stored or
during transport and use.
During transport ensure the bracket is not stressed or damaged by
mechanical forces.
Cleaning
Regularly clean and lubricate the bracket using WD-40 ® or a similar
product.
Inspections
To eliminate the potential risk of accident due to malfunctioning of the
bracket carry out a visual and functional inspection of the bracket
regularly. In particular pay attention to obvious damage (deformation,
cracks and corrosion).
If the bracket fails to operate correctly and/or safely the bracket must
be withdrawn from use immediately.
7. Disposal
Please dispose of this product according to the respective national
regulations.
Ensure that damaged rigging components are disposed of in a way that
they can not be used again.
Z5351 Mounting instructions (1.1 EN) Page 5 of 6