d&b TI 385 d&b Line array design User Manual
d&b Receivers and Amplifiers
Advertising
Table of contents
Document Outline
- 1. Introduction
- 2. The J-Series line array
- 3. The V-Series line array
- 4. The Y-Series line array
- 5. The Q-Series line array
- 6. The T-Series line array
- 7. The xA-Series line array
- 8. The d&b point sources
- 9. Column loudspeakers
- 10. ArrayCalc
- 10.1 ArrayCalc installation
- 10.2 Starting ArrayCalc
- 10.3 ArrayCalc menu options and Toolbar
- 10.4 ArrayCalc workspace
- 10.5 Venue page
- 10.6 Sources page
- 10.7 Line Arrays
- 10.7.1 Array settings
- 10.7.2 Auto Splay
- 10.7.3 Copy, Paste, Paste as new
- 10.7.4 Mechanical load conditions for arrays
- 10.7.5 Array view and load distribution
- 10.7.6 Top view diagram for arrays
- 10.7.7 Profile at array aiming
- 10.7.8 SPL plot and signal selection for arrays
- 10.7.9 Maximum SPL and headroom
- 10.7.10 Air absorption, HFC circuit
- 10.7.11 Array EQ / CPL
- 10.7.12 Level adjustment (Lev/dB)
- 10.7.13 Horizontal arrays of J8, V8, Y8, Q1 and T10 columns
- 10.8 Point sources
- 10.9 Column loudspeakers
- 10.10 SUB arrays
- 10.11 Alignment page
- 10.12 3D plot page
- 10.13 Amplifiers page
- 10.14 Snapshot manager
- 10.15 Rigging plot page
- 10.16 Parts list page
- 10.17 Ground stacked setups
- 10.18 CPL circuit
- 10.19 Time alignment
- 10.20 Equalization
- 11. ArrayProcessing