d&b Z5371 T Flying bracket - Manual (Page 5)

4. Assembly
Note: Make sure that the horn of the T10 cabinet is configured as
a point source.
[1]
[2]
Fig. 5: Assembly
[2]
Fig. 6: Operation
The bracket is locked in place on each side of the cabinet using the two
hand bolts
[2].
NOTICE: Please do not use other fixing screws than those supplied
and specified.
Ensure the two rubber washers
[3] are inserted between
the bracket and the cabinet.
No tools required.
1. Fit the bracket [1] from the rear of the loudspeaker into the
recessed areas of the cabinet side panels.
2. Fix the bracket to the cabinet using the two M10 hand bolts
[2].
5. Operation
Vertical alignment
1. Slacken the hand bolts [2].
2. Set the cabinet to the desired vertical angle.
3. Retighten the hand bolts.
Horizontal alignment
The loudspeaker is aligned horizontally via the Loudspeaker stand
adapter or the TV spigot mounting.
Z5371 Mounting instructions (1.2 EN) Page 5 of 8