d&b Z5378 E6 Horizontal bracket - Manual (Page 4)

2. Intended use
Fig. 3: E6 Wall mounting
Fig. 4: E6 Ceiling mounting
Fig. 5: E6 Truss mounting
The Z5378 E6 Horizontal bracket must only be used in conjunction
with d&b E6 loudspeakers as described in these mounting instructions.
Installation and set up should only be carried out by qualified and
authorized personnel observing the valid national Rules for the
Prevention of Accidents (RPA).
It is the responsibility of the person installing the assembly to ensure
that the suspension/fixing points are suitable for the intended use.
The horizontal bracket can be:
– directly mounted to walls or ceilings.
– horizontally flown and mounted to bars and trusses with a
tube diameter of up to 70 mm (2.75") using the Z5010 TV
spigot with fixing plate and the Z5012 Pipe clamp.
3. Safety precautions
General safety
Always carry out a visual and functional inspection of the bracket
before use. In case you have any doubt as to the proper functioning
and safety of the bracket, do not use it. Please also refer to section 5.
Maintenance and care on page 5.
Load safety information
The maximum permitted working load of the bracket is 5 kg (11 lb)
(according to BGV C1) which corresponds to the weight of one E6
loudspeaker.
4. Assembly
Fig. 6: Tie bar of the bracket
Fixing to walls or ceilings
Two mounting holes 9 mm (0.35“) are provided on the tie bar of the
bracket for fixing the bracket directly to walls or ceilings or other
suitable surfaces.
Attaching the bracket to the cabinet
NOTICE
Only use the screws supplied and specified [2]. Always use the U and
spring washers [3/4] to prevent the bolts from slackening.
Tools required: Open-end spanner/wrench (size #13).
1. Fit the cabinet to the prepared bracket.
2. Bolt the bracket to the cabinet.
3. Set the desired angle before finally tightening the screws.
Z5378 Mounting instructions (1.0 EN) Page 4 of 6