d&b Z5386 V Stack adapter - Manual (Page 4)

1.1. Safety
1.1.1. Intended use
The Z5386 V Stack adapter must only be used in conjunction with
d&b V-Series loudspeakers as described in this manual. It is
intended as a substitute for the V Flying frame in mixed V-Series
ground stacks.
NOTICE!
In addition observe the safety and assembly instructions given in
the ground stack section of the V-Series Rigging manual.
1.1.2. General safety
Installation and setup should only be carried out by qualified and
authorized personnel observing the valid national Rules for the
Prevention of Accidents (RPA).
Always carry out a visual and functional inspection of the items
before use. In case there is any doubt as to the proper functioning
and safety of the items, these must be withdrawn from use
immediately.
Please also refer to Þ Chapter 2. "Care and maintenance /
Disposal" on page 6.
1.2. Scope of supply
Please verify the shipment for completeness and proper condition
of the items.
Qty. d&b Code Description
1 Z5386 d&b V Stack adapter
Including:
1 D2705 Rigging manual
Weight 1.8 kg / 4 lb
1.3. Assembly
WARNING!
Potential risk of personal injury and/or
damage to material!
Always secure ground stacked setups against movement and
possible tipping over.
Observe the maximum number of cabinets permitted. This is
particularly important when setting up mixed ground stacks.
Limitations
A combination of maximum 8 cabinets (SUBs + TOPs) is allowed
to be set up as mixed ground stack.
1. Z5386 V Stack adapter
d&b Z5386 V Stack adapter, Rigging manual (1.1 EN) 4