d&b Z5394 Y Flying adapter - Manual (Page 7)

2. Attach the Flying adapter
1. Attach the Flying adapter on top of the cabinet until the Front
links of the cabinet fit into the slots at the front of the adapter.
2. Insert and lock the Locking pins of the cabinet's Front links on
both sides.
3. On the rear align the Flying adapter with the [0°] hole of the
rear rigging strand.
4. Insert and lock one Locking pin in the [0°] hole.
Note: The second Locking pin is not needed and can be
stored in one of the remaining holes.
3. Prepare the next cabinet
1. Prepare the Front and Splay links of the next cabinet.
4. Preset the splay angle
The splay angles between adjacent cabinets are set at the central
rear rigging strands of the cabinets and can be set in the range
from 0° to 14° in 1° steps.
Þ Preselect the splay angle according to your ArrayCalc
simulation and insert and lock one Locking pin in the
appropriate hole.
d&b Z5394 Rigging manual 1.1 en 7