d&b Z5401 Wall mount S - Manual (Page 5)

The M10 socket of the ball joint adapter allows the loudspeakers
to be connected to different d&b mounting accessories such as:
–
E6532 Super Clamp with
E6533 M10 adapter for Super Clamp
– Z5029 TV spigot
– Z5035 M10 to 3/8" adapter
– Z5034 Stand adapter
Note: Refer to the specific mounting instructions for assembly
and operation of these accessories.
1.4. Mounting options and angle settings
The following mounting options and angle settings are applicable
no matter whether the cabinets are mounted to walls or ceilings or
other suitable surfaces.
4S loudspeaker
Depending on the location of the threaded inserts on the cabinet
(bottom or top), angles can be set in the range from 0° to –90°
(bottom setup) or from 0° to –40° (top setup).
NOTICE!
For unprotected outdoor operation the Z5401 cabinet must be
installed with the M8 inserts located at the top of the cabinet's rear
panel (top setup).
5S loudspeaker
If the 5S cabinet is mounted to a wall, both horizontal or vertical
mounting is possible. Angles can be set from 0° to –38° (vertical
set up) or 0° to –70° (horizontal setup).
If the cabinet is mounted to a ceiling, the horizontal setup is
recommended.
1.5. Assembly
Tools required:
– Open-ended spanner/wrench (size #13 and #17)
– Allen hex key 3 mm
Mounting plate M10
NOTICE!
Only use mounting parts (fixing anchors and screws) that are
suitable for the intended application.
To mount the 4S and 5S cabinets to walls, ceilings or other
surfaces, use the Mounting plate M10.
A corresponding fixing template is supplied with these mounting
instructions. Refer to Þ Chapter 2. "Fixing template"
on page 7.
d&b Z5401 Wall mount S, Mounting instructions (1.2 EN) 5