2 dcp-2000 analog (ana) audio connector - optional, 2 doremi aud-d2a - audio converter – Doremi DCP-2000 User Manual
Page 5
2.1.2 DCP-2000 Analog (ANA) Audio Connector - Optional
The DCP-2000 analog un-balanced audio output connector pin-out follows:
2.2 Doremi AUD-D2A - Audio Converter
The AUD-D2A is an 8 channels digital to analog audio converter that can be connected between
the DCP-2000 digital audio output and an analog audio input of analog audio processor.
Its audio I/Os are located on the rear panel as presented below:
Figure 3: AUD-D2A Rear Panel
Note: The AUD-2A has the same analog output wiring scheme as the internal DCP-2000 analog
audio output (which is optional in the DCP-2000).
D2K.OM.000663.DRM
Page 5
Version 1.2
Doremi Cinema LLC
Pin #
Signal Description
Pin #
Signal Description
1
Ch 8 plus
14
no connection
2
Ch 8 ground
15
Ch 7 plus
3
no connection
16
Ch 7 ground
4
Ch 6 plus
17
no connection
5
Ch 6 ground
18
Ch 5 plus
6
no connection
19
Ch 5 ground
7
Ch 4 plus
20
no connection
8
Ch 4 ground
21
Ch 3 plus
9
no connection
22
Ch 3 ground
10
Ch 2 plus
23
no connection
11
Ch 2 ground
24
Ch 1 plus
12
no connection
25
Ch 1 ground
13
no connection
Analog Audio Output
Digital Audio Input
DCI Channel Map:
Channel 1: L
(screen, left)
Channel 2: R
(screen, right)
Channel 3: C
(screen, center)
Channel 4: LFE (screen, low frequency
effects subwoofer)
Channel 5: Ls
(surround, left wall)
Channel 6: Rs
(surround, right wall)
Channel 7: Lc
(screen, mid left to
center)
Channel 8: Rc
(screen, mid right to
center)
Pin 1
Pin 25
Pin 2
Pin 13
Pin 14