Future Automation LSM-TU-EFA - Manual (Page 10)

In
st
al
la
ti
o
n
:
S
ta
ge
5
Page 9 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
LSM TU EFA -
Lift System Medium Telescopic Unit Electric Flap Actuator
Routing Cables
With Telescopic Unit (TU) still in the up position, remove the top TU cover as shown.
Thread the screen and power cables through the back of the cabinet into the lower Cable
Management Chain (CMC). Then run the cables into the lifting beam and into the side
chanels of the TU, you may need to remove the lower cover to help aid the cables which is
held in place by 2 bolts at the base and 2 plastic sliding plugs which snap in and out.

SLIDING PLUGS
LIFTING BEAM
TU SIDE CHANELS
LOWER CMC
TU CMC
Run the cables into the CMC in the TU as
shown with the dotted line and out of the top
ready to plug into the screen. If threading the
cables through the TU become tight you can
go further along the liftinging beam and up
the other side. Fix covers back back in place.