Future Automation LSM-TU-EFA - Manual (Page 12)

In
st
al
la
ti
o
n
:
S
ta
ge
7
Page 11 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
LSM TU EFA -
Lift System Medium Telescopic Unit Electric Flap Actuator






You can adjust the IN and OUT position of the lifting beam. Detail 1 shows how
to adjust the OUT position and detail 2 shows how to adjust the IN position.
The IR sensor can be located anywhere outside of the cabinet.
Switch Adjustments
1
2
1 - The top switch can’t be adjusted
when the mechanism is in the OUT
position, because the switch is active.
Lower the mechanism and press
STOP about 100mm [4”]. Then adjust
the OUT switch plate by loosening
the bolts and sliding the plate.
2 - Height of the lower
post determines the
IN position