Holland Electronics HMPS - Manual

HMPS
Power Supply
HMPS SPECIFICATIONS :
AC INPUT: 95-240VAC (50-60Hz)
DC OUTPUT : 2@ 12VDC
OUTPUT CURRENT : 2 Ampere (Each of 2 outputs)
PROTECTION: Short Circuit & Overload
REGULATION: 5%
RIPPLE: 25mV
Installation Instructions
1. Slide HMPS unit into the far right side of the HMR rack.
2. Plug in AC power cord into the rear of the HMPS unit.
3. Plug in one end of brown and black wired jumper to rear of HMPS.
4. Connect the other end of brown and black wired jumper to HMMS or HMD unit to be powered.
5. Plug in one end of the AC power cord into the rear of the HMPS unit.
6. Connect the other end of the AC power into a surge protected 95-240 VAC source.