ILUMINARC Ilumipanel™ 40 IP - Manual (Page 14)

Installation
10 Ilumipanel 40 IP Optic RGB User Manual
To assign
individual DMX
addresses to
each product,
you must connect the
ILUMICODE
ADDRESSER to each
product, individually.
ILUMINARC®
suggests that you
connect no more
than 20 products
in this mode and keep the
total distance to less than
60 m (197 ft). Otherwise,
you might need to use an
optically isolated signal
amplifier.
ILUMICODE ADDRESSER
The Ilumipanel 40 IP Optic RGB uses the ILUMICODE ADDRESSER (“Ilumicode”)
for configuration purposes. The diagram below shows how to connect the Ilumicode to
this product. This connection will control multiple products at the same time, all having
the same DMX address.
Important: The Ilumicode must be used to configure this product. The Ilumicode
can be purchased separately through your ILUMINARC® sales representative.