ILUMINARC Ilumipanel™ 40 IP - Manual (Page 6)

Introduction
2 Ilumipanel 40 IP Optic RGB User Manual
There are no
user-serviceable
parts inside this
product. Any reference to
servicing you may find in
this User Manual will only
apply to properly certified
ILUMINARC
®
technicians. Do not open
the housing or attempt
any repairs unless you
are certified to do so.
Please refer to all
applicable local codes
and regulations for the
proper installation of this
product.
Keep this manual for
future consultation. If you
sell this product to
another user, make sure
that they also receive this
manual.
In the unlikely
event that your
Ilumipanel 40 IP
Optic RGB may require
service, please contact
ILUMINARC
® Technical
Support.
Safety Notes
Please read all the following Safety Notes carefully because they include important information
on how to install, use, and maintain this product safely.
Personal Safety
· Avoid direct eye exposure to the light source while the product is on.
· Always disconnect this product from its power source before servicing.
· Always connect this product to a grounded circuit to avoid the risk of electrocution.
· Do not touch this product’s housing when operating because it may be very hot.
Mounting and Installation
· This product is for outdoor use and can be submerged (IP67). However, do not
submerge deeper than 1 m for more than thirty (30) minutes.
· CAUTION: When transferring product from extreme temperature environments,
(e.g. cold truck to warm humid ballroom) condensation may form on the internal
electronics of the product. To avoid causing a failure, allow product to fully acclimate to
the surrounding environment before connecting it to power.
· Make sure there are no flammable materials close to this product while it is operating.
· When hanging this product, always secure it to a fastening device using a safety cable.
Power and Wiring
· Always make sure that you are connecting this product to the proper voltage per the
specifications in this manual or on the product’s sticker.
· Never connect this product to a dimmer pack.
· Make sure that the power input cable is not cracked, crimped, or damaged.
· Never disconnect this product by pulling on the power cable.
Operation
· The maximum ambient temperature is 104° F (40° C). Do not operate this product at a
higher temperature.
· In case of a serious operating problem, stop using this product immediately!