Monroe Electronics R197AV User Manual

Page 23

Advertising
background image

23. Select the second

2

active (enabled) station in the Select Station Configuration

Interfaceusing the pull down. (Note: Active (enabled) stations are identified with a asterisk [*]
preceding the name.

24. On the far right side of settings table will be the Net GPIO ‘R197AV list as highlighted in
Error: Reference source not found. Recognize the name R197AV between the quotes is
the name previously assigned to the client. This may be different if another name was used.

25. In the Net GPIO ‘R197AV’ table select the Net GPO number that corresponds to the switch
wired for this station. Clicking on this selection will highlight the selection and assign this
closure to this station.

2

This assumes that station one is configured to switch using the internal DASDEC program switch, therefore

stations 2, 3, 4 & 5 would be externally switched.

23

Advertising