NEXCOM PEAK 876VL2 User Manual
Page 41
Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved.
28
Chapter 3: BIOS Setup
PEAK 876VL2/877VL2 User Manual
BIOS SETUP UTILITY
← →
Select Screen
↑↓
Select Item
+-
Change Field
F1
General Help
F10 Save and Exit
ESC Exit
IDE Configuration
Mirrored IDER Configuration
[Enabled]
Configure SATA as
[IDE]
SATA1 IDE Configuration
[Compatible]
SATA2 IDE Configuration
[Enhanced]
u
Primary IDE Master
: [Not Detected]
u
Primary IDE Slave
: [Not Detected]
u
Secondary IDE Master
: [Not Detected]
u
Secondary IDE Slave
: [Not Detected]
u
Third IDE Master
: [128M]
u
Fourth IDE Master
: [Not Detected]
IDE Detect Time Out (Sec)
[35]
Advanced
IDE Configuration
This section is used to configure the IDE drives.
Mirrored IDER Configuration
The options are Enabled and Disabled.
Configure SATA As
IDE
This option configures the Serial ATA drives as Parallel ATA physi-
cal storage device.
RAID This option allows you to create RAID or Intel Matrix Storage
configuration on Serial ATA devices.
AHCI This option configures the Serial ATA drives to use AHCI (Ad-
vanced Host Controller Interface). AHCI allows the storage driver
to enable the advanced Serial ATA features which will increase
storage performance.
v02.67 (C)Copyright 1985-2009, American Megatrends, Inc.
SATA1 IDE Configuration and SATA2 IDE Configuration
Configures the Serial ATA controller to Compatible or Enhanced mode
Primary IDE Master to Fourth IDE Master
When you enter the BIOS Setup Utility, the BIOS will auto detect the ex-
isting IDE devices then displays the status of the detected devices. To con-
figure an IDE drive, move the cursor to a field then press <Enter>.
IDE Detect Time Out (Sec)
Selects the time out value for detecting ATA/ATAPI devices.
IDE
RAID
AHCI
Disabled
Options