NEXCOM VTC 6110 - Manual (Page 18)

Copyright © 2009 NEXCOM International Co., Ltd. All Rights Reserved. 4 VTC 6110 User Manual
Chapter 1: Product Introduction
Power Management
Power-on delay time is selectable by BIOS to disable and enable in 10sec •
/ 30sec / 1min / 5min / 10 min / 15min / 30min / 1hr.
Power-off delay time is selectable by BIOS to disable and enable in 20sec
•
/ 1min / 5min / 10min / 30min / 1hr / 6hr / 18hr.
S3, S4 suspend mode
•
• Ignition On/Off status detectable by SW
• Low battery status detectable by SW
Ignition enable/disable is jumper selectable •
Shut down system automatically when the system’s internal temperature •
is over 80C.
VTC 6110 will automatically shut down 5 minutes after the duration
•
of low battery voltage is over 60 sec. User can detect this situation via
software.
If the ignition is off and the system is still on after 3 minutes, VTC 6110
•
will shut down automatically.
If the ignition is off, the user can detect this status via the software.
•
If the ignition is turned on again and the power-off delay is in progress, •
VTC 6110 will cancel the delay function and will continue to operate
normally.
If the ignition is turned on again and the power-off delay ended, VTC
•
6110 will shut down completely will power-on again automatically.
If the ignition is turned off again and power-on delay is in progress, VTC
•
6110 will cancel the delay and stay in power-off status.
If the ignition is turned off again and the power-on delay ended (en-
•
tered OS already), VTC 6110 will continue to operate normally.
If the ignition is turned off again and the power-on delay ended (in BIOS •
process), VTC 6110 will shut down immediately.
If VTC 6110 is off, only below 10mA is used.
•