Oklahoma Sound #LSS - Manual (Page 3)

3
Step 1:
a) Begin by idenƟfying panel #A and lying it on a
clean, soŌ surface face down. (white side
facing up)
b) Take the steel base frame, panel #B and place
it over the panel as shown with the caster
wheel nuts facing upwards.
c) The four holes on the metal frame should
align with the four embedded T-nuts in panel
#A.
d) Use four bolts # 3 to secure the panel #B to
panel #A by inserƟng the bolts through the
holes on panel #B and screw them into t-nuts
on panel #A as shown.
e) Use a Phillips screwdriver to Ɵghten the bolts
securely.
Step 2:
a) Locate your four casters, two non-locking # 8
and two locking #9.
b) Install all four casters by threading the stem
of the casters into the caster nuts located at
each corner as shown.
c) The two locking casters # 9 should be in-
stalled in the front of the unit. You can idenƟ-
fy the front of the unit by noƟcing the round-
ed side of panel #A as shown in the illustra-
Ɵon.
a) Use the provided open-end wrench part #11
to properly secure the casters to the frame.
Front end
(8)
(9)
(8)
(9)